Loads to codes

Нашли неточность или ошибку в расчёте? Пожалуйста, сразу напишите на [email protected] или через форму обратной связи — буду благодарен!

ShNK 2.01.07-21 · Uzbekistan

Snow on vaulted, lantern and multi-span roofs to ShNK 2.01.07-21

Snow distribution variants of Annex 3: vault (μ1 = cos 1.8α, μ2 = 2.4 sin 1.4α), longitudinal lantern, sawtooth, multi-span duopitch and vaulted roofs.

Results

Detailed report

About this calculation

Snow distribution variants of Annex 3: vault (μ1 = cos 1.8α, μ2 = 2.4 sin 1.4α), longitudinal lantern, sawtooth, multi-span duopitch and vaulted roofs.

Design basis

ShNK 2.01.07-21, Annex 3, schemes 2, 4, 6, 7, 8

Input data

Output

FAQ

Where do I get the ground snow load s0 and the wind pressure w0?

From maps 1 and 3 of ShNK 2.01.07-21 Annex 5 — on the Uzbekistan zone map on this site. For the settlements listed in Annex 5 Tables 1 and 3 the tabulated value applies; in the mountain districts of Table 2 the snow load depends on the site altitude.

How does ShNK 2.01.07-21 differ from SP 20.13330?

Both grew out of SNiP 2.01.07-85: the wind load is the mean component wm = w0·k·c plus the pulsating one, the snow load is s = s0·μ with the Annex 3 schemes. Zones, w0 and s0, the snow drift reduction and several tables are national.

What load safety factors apply?

Wind — γf = 1.4 (cl. 87). Snow — 1.4; 1.6 if the characteristic roof dead load is below 0.8·s0 (cl. 73). The calculators show characteristic and design values.

Share:VKfTgWA@Xin微博QQQzone